Metal house numbers, plaque, housewarming, address sign, Custom metal address sign, custom street address sign, wall, Rock, tree, pines

Custom metal personalized address sign/house numbers for your rock or wall with tree design. Finished with highly durable exterior matte black powder coating. This address sign is made out of highly quality durable/sturdy 1/8 inch thick steel(12gauge). This gives the item a very sturdy feel. Item comes as shown in listing photos numbers are offset to the right. Upon request we can center the numbers or offset to the left. Just leave us a message at check out. We will send you a mock-up of the design.

**This item is a metal sign that will mount to your rock or wall. No rock is included with the purchase.**

-Rock mount comes with two posts welded to back of sign

-Wall mount comes with two holes for mounting, 1 inch standoffs and color matched screws. 

If the sign is ordered without the text on the bottom the size will come out to 22 inches wide by 6 inches tall. This can be modified just leave a note at check out or reach out to us before you order.

This sign is built to mount to a rock by drilling 5/8 inch holes into your large rock and glued into place using fast setting construction adhesive. The sign has two post welded to the back side. The sign can also be made without the back post/rock install parts. This would allow the sign to mount to a wall. We do custom work as well. Made out of 12 gauge steel. Sign has a matte black powder coated finish. Size is 10 inch tall by 22 inch wide. The height varies depending on address length.

Total size is 9.5x22 inches but height can vary due to text length. The width stays 22 inches.

We will make our best judgement on the best length for your personalized text unless we hear from you with any size requirements or specific instructions. These must be present with your order (you can add notes in the cart before you proceed to checkout, email, or message us within 2 hour of your order. After the 2 hour mark, your order might be designed and cut and any instructions/cancelation will be invalid.) Buyer is responsible for verifying and inputting the correct spelling and information for personalization when placing the order and reviewing the mock-up.

Instructions:
1. Hold sign in place and mark post positions on rock
2. Drill holes using a roto hammer or hammer drill with a 5/8 or 3/4" masonry drill bit.
3. Clean holes out as best as possible.
4. Fill holes with your choice of concrete adhesive or hydraulic cement. Make sure adhesive is fast setting.
5. Hold sign in place till adhesive or cement sets. You can use blocking or string from a tree branch to hold the sign in place.
6. Wipe sign clean with a damp micro fiber towel.

All of our products are made in the USA with American made steel.

Free shipping excludes Hawaiian islands and Alaska. Please contact us before purchasing if you would like to ship to these areas. Additional cost may apply.